Re: [PATCH/RFC RESEND] leds: Use set_brightness_work for brightness_set ops...
On 06/30/2015 01:58 PM, Pavel Machek wrote: > On Tue 2015-06-30 10:01:08, Jacek Anaszewski wrote: >> This patch rearranges the core LED subsystem code, so that it >> now removes from...
View ArticleRe: [PATCH 1/2] perf: create config.detected into OUTPUT directory
On Wed, Jul 01, 2015 at 02:54:42PM +0300, Aaro Koskinen wrote: > Create config.detected into OUTPUT directory instead of source directory. > This fixes parallel builds that share the same source...
View ArticleRe: [PATCH 2/2] perf: allow to specify custom linker command
On Wed, Jul 01, 2015 at 02:54:43PM +0300, Aaro Koskinen wrote: > Allow to specify custom linker command. This fixes MIPS64 builds for > 64-bit userspace as it will allow to pass a linker using...
View Article[PATCH 1/3] regulator: max8973: Fix up control flag option for bias control
The control flag for the bias control is MAX8973_CONTROL_BIAS_ENABLE rather than MAX8973_BIAS_ENABLE which is macro for the bits in register. Fix this typo. Signed-off-by: Laxman Dewangan...
View Article[PATCH 3/3] regulator: max8973: add support to configure ETR based on rail load
Add support to configure Enhanced Transient Response Enable (ETR) and Sensitivity Selection based on maximum current i.e. expected load on that rail. Maxim recommended as: - Enable ETR with high...
View Article[PATCH 2/3] regulator: max8973: add support to configure ETR from DT
The MAX8973/MAX77621 feature an Enhanced Transient Response(ETR) circuit that is enabled through software. The enhanced transient response reduces the voltage droop during large load steps by...
View ArticleRe: n900 in 4.2-rc0: repeating oopses
On Wed 2015-07-01 03:34:22, Tony Lindgren wrote: > * Pavel Machek <pavel@ucw.cz> [150701 03:02]: > > On Wed 2015-07-01 09:22:55, Pali Rohár wrote: > > > On Tuesday 30 June 2015...
View ArticleRe: [PATCH v3 4/5] perf mem: Fill in the missing freeing a session after an...
On Wed, Jul 01, 2015 at 08:59:48PM +0900, Taeung Song wrote: > When an error occur a error value is just returned > without freeing the session. So allocating and freeing > session have to be...
View Article[PATCH v3 0/4] cpufreq: use generic cpufreq drivers for Exynos5250 platform
Hi, This patch series removes the use of Exynos5250 specific support from cpufreq-exynos driver and enables the use of cpufreq-dt driver for this platform. This patch series has been tested on...
View ArticleRe: [PATCH v7 09/16] libnvdimm, pmem: move pmem to drivers/nvdimm/
Hi Dan, On Thu, Jun 18, 2015 at 1:14 AM, Dan Williams <dan.j.williams@intel.com> wrote: > Prepare the pmem driver to consume PMEM namespaces emitted by regions of > an nvdimm_bus instance....
View Article[PATCH v3 1/4] clk: samsung: exynos5250: add cpu clock configuration data and...
From: Thomas Abraham <thomas.ab@samsung.com> With the addition of the new Samsung specific cpu-clock type, the arm clock can be represented as a cpu-clock type. Add the CPU clock configuration...
View Article[PATCH v3 2/4] ARM: dts: Exynos5250: add CPU OPP and regulator supply property
From: Thomas Abraham <thomas.ab@samsung.com> For Exynos5250 platforms, add CPU operating points and CPU regulator supply properties for migrating from Exynos specific cpufreq driver to using...
View Article[PATCH v3 3/4] ARM: Exynos: switch to using generic cpufreq driver for...
From: Thomas Abraham <thomas.ab@samsung.com> The new CPU clock type allows the use of generic CPUfreq driver. Switch Exynos5250 to using generic cpufreq driver. Changes by Bartlomiej: - split...
View Article[PATCH v3 4/4] cpufreq: exynos: remove Exynos5250 specific cpufreq driver...
Exynos5250 based platforms have switched over to use generic cpufreq driver for cpufreq functionality. So the Exynos specific cpufreq support for these platforms can be removed. Based on the earlier...
View ArticleRe: [PATCH v3 4/5] perf mem: Fill in the missing freeing a session after an...
I’m sorry. I made a mistake. So I sent again patch mail as [PATCH RESEND v3 4/5] Thanks, Taeung > On Jul 1, 2015, at 10:09 PM, Jiri Olsa <jolsa@redhat.com> wrote: > > On Wed, Jul 01,...
View Article[PATCH V5 0/2] da9062: DA9062 driver submission
From: S Twiss <stwiss.opensource@diasemi.com> This patch set adds support for the Dialog DA9062 Power Management IC. In this patch set the following is provided: - [PATCH V5 1/2]: MFD core...
View Article[PATCH V5 1/2] mfd: da9062: DA9062 MFD core driver
From: S Twiss <stwiss.opensource@diasemi.com> Add MFD core driver support for DA9062 Signed-off-by: Steve Twiss <stwiss.opensource@diasemi.com> --- Changes in V5: - Alter register.h file...
View Article[PATCH v5 3/3] ARM: exynos: Add exynos3250 compatible to use generic cpufreq...
This patch add exynos3250 compatible string to exynos_cpufreq_matches for supporting generic cpufreq driver on Exynos3250. Cc: Kukjin Kim <kgene@kernel.org> Cc: Krzysztof Kozlowski...
View Article[PATCH v5 2/3] ARM: dts: Add CPU OPP and regulator supply property for...
This patch add CPU operating points which include CPU frequency and regulator voltage to use generic cpufreq drivers. Cc: Kukjin Kim <kgene@kernel.org> Cc: Krzysztof Kozlowski...
View Article[PATCH V5 2/2] devicetree: da9062: Add bindings for DA9062 driver
From: S Twiss <stwiss.opensource@diasemi.com> Add device tree bindings for the DA9062 driver Signed-off-by: Steve Twiss <stwiss.opensource@diasemi.com> --- Changes in V5: - No change...
View Article